Abstract:
Different series of polycrystalline superconductor, Cu0.5Tl0.5Ba2Ca4-xMgxCu5O14-δ
(x = 0, 1, 2 and 3), (Cu0.5Tl0.5)Ba2Ca2Cu3-yGeyO10- (y = 0, 0.5, 0.75 and 1.0) and
(Cu0.5Tl0.5)Ba2Ca3(Cu4-yGey)O12- (y = 0, 0.3, 0.6 and 0.9) have been synthesized by
solid-state reaction method. The structure and physical properties were investigated by
powder X-ray diffraction (XRD), resistivity, ac-susceptibility and Fourier transform
infrared absorption spectroscopy (FTIR). X-ray diffraction scans of polycrystalline
samples of Cu0.5Tl0.5Ba2Ca4-xMgxCu5O14-δ (x = 0, 1, 2 and 3) samples show tetragonal
structure following P4/mmm space group. The dominant phase in x = 0 sample is CuTl-
1234 while the remaining all Mg doped samples show the projected CuTl-1245 phase
with a small inclusion of impurity phases. It suggests that the presence of Mg plays a
very vital role in synthesis of five planar CuTl-1245 compounds. With the partial
substitution of Ca with Mg in the samples, the CuO2 planes become uniformly doped due
to improved inter-planer coupling which results in the enhancement of Tc (R = 0) as well
as the magnitude of diamagnetism. Further superconducting properties of the samples
have been enhanced by carrying out annealing experiments in nitrogen air and oxygen
atmospheres. The enhanced superconductivity in different annealing environments have
been attributed to the optimization of carrier density in the OPs and the IPs. Oxygen
annealed samples show the best superconductivity among all, which have been attributed
to the optimization of carrier concentration in the CuO2 planes and improved weak link
behavior due to the intercalation of the oxygen in the unit cell and at the intra-grain and
inter-grain sites. Superconductivity in the Cu0.5Tl0.5Ba2Ca2Mg2Cu5O14- superconductor
has been optimized by varying both time and temperature during the air annealing
experiments by attaining Tc ~ 132 K. In (Cu0.5Tl0.5)Ba2Ca2Cu3-yGeyO10- (y = 0, 0.5, 0.75
and 1.0) samples, synthesized at 860oC, y = 0 and 0.5 show the CuTl-1223 tetragonal
phase but y = 0.75 and 1.0 develop CuTl-1234 as the dominant phase. It indicates that the
substitution of Ge lowers the synthesis temperature and for single phase sample,
temperature less than 860oC seems more plausible. Four planar Ge doped
(Cu0.5Tl0.5)Ba2Ca3(Cu4-yGey)O12- (y = 0, 0.3, 0.6 0.9) superconductors were prepared at
870oC rather than 880oC and investigated for their superconducting properties. X-ray
diffraction scans of the samples confirm the CuTl-1234 phase. Increased Ge substitution
at the Cu planar sites has been found to suppress the superconducting properties of the
samples. Possible causes include the impurity scattering and the carrier depletion due the
replacement of Cu2+ ions with Ge4+ ions. The superconductivity has been restored by
carrier doping through annealing processes. FTIR analysis has also been conducted and
the role Ge in the variations of different phonon modes has been discussed. Also the
effect of oxygen annealing on these phonon modes have been observed and analyzed.
The fluctuation induced conductivity of Cu0.5Tl0.5Ba2Ca4−xMgxCu5O14−δ (x = 1, 2) and
Cu0.5Tl0.5Ba2Ca2Cu2M1O10- (M =Si, Sn, Ge) superconductor samples has been done. FIC
data of the as-prepared Cu0.5Tl0.5Ba2Ca4−xMgxCu5O14−δ (x = 1) sample does not fit with
2D, 3D AL equations, but for x = 2 and the oxygen annealed samples seem to fit well
with 2DAL, 3D AL equations with two distinct cross over temperatures. In the samples
the interlayer coupling strength J is found to increase with increased Mg content and
oxygen post annealing. Higher concentration of Mg seems to lower the anisotropy along
the c-axis and thus improves the inter-planer coupling. It results in 2D to 3D cross over of
the conductivity and enhancement of the interlayer coupling strength J. The 2D to 3D
cross over and higher J values in post annealed samples can be attributed to the change in
the carrier concentration in the CuO2 planes, and improved weak link behavior, brought
about by the intercalation of the oxygen in the charge reservoir layer. The excess-
conductivity data of Cu0.5Tl0.5Ba2Ca2Cu2M1O10- (M = Si, Sn and Ge) samples also shows
two cross over temperatures and three distinct exponents. Si and Sn doped samples with
almost same critical temperature have not shown much diversity in different parameters
such as room temperature resistivity, transition width, (N 0 K) etc. Similarly not much
difference is seen in the dimensionality exponents and the corresponding temperature
ranges. The Ge doped sample with lower critical temperature has shown different FIC
parameters with large transition width. Ge doped sample has shown higher 3D character;
in this sample 2D fluctuations are found in very small temperature range. Here a possible
link between the confinement of the 2D fluctuations to a narrow temperature window and
the lower critical temperature of the Ge doped sample can be conjectured but not
claimed.