PASTIC Dspace Repository

Browsing Technical Journal by Title

Browsing Technical Journal by Title

Sort by: Order: Results:

  • Non Functional Requirement in Agile Software 
    Aziz, Y.; Aziz, T.; Malik, M. I.; Baig, M. K.; Ali, M. Z.; Baqer, M. (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-03-15)
    Agile Software Development (ASD) is very popular worldwide for developing software applications efficiently according to dynamic user's requirements. Previously, Traditional Software Engineering (TSE) was used but unplanned ...
  • Non-Standard Finite Difference Modeling for Transmission Dynamics of Dengue Fever 
    M. Rafiq; M. O. Ahmad (Taxila: University of Engineering and Technology, Taxila, 2016-03-15)
    Mathematical models have been widely used in various areas of infectious disease epidemiology. In this paper, the transmission dynamics of a vector borne infectious disease "Dengue Fever" has been analyzed numerically. An ...
  • Non-Standard Finite Difference Scheme for the Kinetics of Pentaerythritol Production Reactions 
    M. Basit; S. Riaz; M. Rafique; Q. A. Chaudhry; S Farid (Taxila: University of Engineering and Technology, Taxila, 2016-03-14)
    Pentaerythritol plays very crucial role in the preparation of many polyfunctionalized compounds such as explosives, dyes, paints and surface coatings. Estimation of numerical solutions of kinetics of pentaerythritol ...
  • Nonlinearity Index And Structural Analysis–based System Identification Using Modal Assurance Criterion (MAC) 
    Rehman, A. U.; Ali, Q.; Gardezi, A. R.; Hayat, N.; Farhan, M.; Sajid, R. (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-02-12)
    It is well known that all the dynamic system has some level of nonlinearity. This nonlinearity is caused from numerous sources that can be classified differently (e.g. material, geometry and contact). In this work a relative ...
  • Notch Fatigue Behavior of Aluminum 2024-T6 in Four Point Bending Rotation 
    Anjum, N. A; Anjum, S; Abbas, Z; Mehmood, S; Anwar, W (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-02-11)
    In some engineering applications rotating machinery components experience bending stresses due to location supports or misalignments, which often leads to fatigue degradation of critical components. This effect is enhanced ...
  • Off Shore Wind Turbines: A Solution To Energy Crisis In Pakistan 
    M. M. A. Bhutta; M. A. M. Qureshi; M. A. Ahmad; S. A. Ahmad; A. A. Bhutti (Taxila: University of Engineering and Technology, Taxila, 2016-05-09)
    There is increasing power and energy shortage in Pakistan from last two decades. It is the need of the time to explore new avenues for power production, keeping in view the environmental impact and the concept of sustainability. ...
  • Optical Character Recognition (OCR) System For Saraiki Language Using Neural Networks 
    M. T. Jan, Y. Saleem (Taxila: University of Engineering and Technology, Taxila, 2016-09-14)
    Saraiki language is one of the local languages of Pakistan. It is spoken and understood over a large geographical part of Pakistan. Little work has been done to develop Optical Character Recognition systems for local ...
  • Optimal Techniques of Localization in Wireless Sensor Networks 
    'Y. Salam; M. Farooq; 4M. Rizwan (Taxila: University of Engineering and Technology, Taxila, 2016-12-15)
    -Localization in wireless sensor networks is an open challenge. The work is based on the localization of mobile nodes in wireless sensor networks (WSN) by using the Received Signal Strength Indicator (RSSI) method. A ...
  • Performance and Comparison of Crumb Rubber Modified and Conventional Mixes Under Varying Temperature and Stress Levels 
    M.A. Karnali; S. Shahid'; M.U.Arshid; I. Hafeei (Taxila: University of Engineering and Technology, Taxila, 2016-04-02)
    Laboratory investigations were carried out in terms of resistance against rutting and assessing resilient modulus of Crumb Rubber Modified Mixes (CRMM) and conventional mixes (60/70 pen) at varying temperatures (55, 40, ...
  • Performance Evaluation of AODV, DSDV and DSR Routing Protocols in Unplanned Areas 
    Saeed, N; Amin, R.U; Malik, A.S; Kasi, M.K; Kasi, B (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-03-20)
    -It is important to explore how VANET Routing protocols behave in unplanned areas which lacks fixed infrastructure such as Road Side Unit to support vehicular communication. Furthermore, such areas do not possess vehicular ...
  • Performance Evaluation of Sodium Bentonite Material for Seepage Control in Irrigation Channels 
    Shehzad, T; Yaseen, Muhammad; Afzal, M; Khan, M; Rizwan, M.A; Ahmad, S.R; Bhatti, H.A (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-01-01)
    Irrigation canals in Pakistan suffer tremendous water seepage losses due to unlined section of the canal. As most of canals are unlined, large amount of water is wasted in terms of seepage especially in link canal. When ...
  • Performance of RC Columns Confined with Welded Wire Mesh Around External and Internal Concrete Cores 
    Tahir, M. F.; Khan, Q. U. Z.; Shabbir, F.; Ijaz, N.; Malik, A. A. (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-01-02)
    -Effectiveness of locally available welded wire mesh (WWM) as an additional confinement in reinforced concrete square columns was evaluated under axial loads. For this purpose three groups of 200×200×975mm square column ...
  • Power Optimization using Low-Transition Rate based LFSR Pattern Generator 
    Durrani, Y. A (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-04-08)
    Dynamic power dissipation has been increased exponentially with the excessive switching of nodes inside the digital electronic circuits. Power dissipation on these circuits are highly input pattern dependent. This work ...
  • Prediction of CBR Value from Index Properties of different Soils 
    Rehman, Z. U; Khalid, U; Farooq, K; Mujtaba, H (Taxila:University of Engineering and Technology(UET)Taxila, Pakistan, 2017-04-03)
    A Prediction is a vital tool in engineering used to take right decisions. Therefore, it is very important for engineers to quickly predict the behavior of geomaterials used in the infrastructures. California Bearing Ratio ...
  • Process Improvement for PET Bottles Manufacturing Company Using Six Sigma Approach 
    M. Ullahl; A. M. Khan; R. Nawaz; R. Akhtar (Taxila: University of Engineering and Technology, Taxila, 2016-06-10)
    Rejection in production processes cannot be ignored in industries in general, and in manufacturing organizations in particular. Six sigma has been considered an organized and scientific approach for the last few decades ...
  • Reactive Power Control of A 220kv Transmission Line Using PWM Based Statcom with Real Time Data Implementation 
    A. Mahmood; M. Amjad; M. I. Malik; A. Al; A. Muhammad (Taxila: University of Engineering and Technology, Taxila, 2016-02-05)
    Abstract-Static Synchronous Compensator (STATCOM) is the best device for reactive power compensation and power system stability. In this paper a novel STATCOM model is proposed. The STATCOM model used in this paper used a ...
  • Reduction of Damages Through Pre-Flood Management Strategies: Case Study of District Bhakkar in Punjab-Pakistan 
    Z. Shahid, A. Hussain (Taxila: University of Engineering and Technology, Taxila, 2016-07-03)
    Climate change has daunting impacts on various socio-economic sectors such as water, agriculture, health, biodiversity and forests etc. Unprecedented climate change and heavy rainfall are the most significant causes of ...
  • Relaxing the Planning Standards of Housing Scheme: An Approach to Enhance Affordability of Poor 
    M. Asim; M. M. Arif; A. Azii; A. Adeel (Taxila: University of Engineering and Technology, Taxila, 2016-07-01)
    Affordable housing is growing as major concern in the world with incremental increase in urban population and substandard provision of housing for low income sector. We can diminish housing shortage by Improving bidding ...
  • Reverse Logistics A Tool for Organizational Excellence; A Pakistani Perspective 
    U. Hameed, G. Zailin; G. Zakria, W. Ahmed; M. B. Raza (Taxila: University of Engineering and Technology, Taxila, 2016-08-11)
    Due to intense competition and globalization, the challenges associated with providing products and services at the right time and place as well as at the lowest possible costs have increased. The practicing of Supply Chain ...
  • A Review on Extrinsic Registration Methods for Medical Images 
    F. Alm, S. U. Rahman; S. Ullah, A. Khalif; A. U. Din (Taxila: University of Engineering and Technology, Taxila, 2016-09-15)
    In medical image analysis, image registration is the process of mapping the features or coordinate space of one image with the features or coordinate space of another image. The main aim of medical image registration is ...

Search DSpace


Advanced Search

Browse

My Account