Abstract:
The aim of the present research was to assess the metal phytoextraction
potential of some selected plant species (Hemarthria compressa L., Lemna minor
L. and Typha angustifolia L.) growing on industrial sludge along with resistant
microbial strains (Aspergillus terreus, Aspergillus niger, Bacillus sp. and
Acinetobacter sp.) either alone or in combinations. Based upon the result of
preliminary experiments, the sludge concentrations selected for the actual greenhouse
and field experiments were 30 and 60% along with control (0%). Keeping
in view the metal resistance efficiency of microbes, the experiment comprised of
seven treatments i.e., C (control without microbes), F1 (Aspergillus terreus), F2
(A. niger), F1+F2 (A. terreus + A. niger), B1 (Bacillus sp.), B2 (Acinetobacter sp.),
B1+B2 (Bacillus sp. + Acinetobacter sp.), respectively. Six independent
experiments (4 green-house and 2 field) were launched simultaneously. Physicochemical
analysis of initial sludge samples revealed that tannery and paper
sludge had a high pollution load due to higher values of pH, conductivity, total
dissolved solids (TDS), sodium chloride (NaCl), biochemical oxygen demand
(BOD), chemical oxygen demand (COD) and metals like Cr, Cd, Zn, Cu and Pb.
After 90 days of plant growth in sludge, the growth was significantly decreased
with increase in the concentration of sludge. On the other hand, in sludge
concentrations along with microbial inoculum, plants showed the maximum shoot
length, roots, leaves and fresh/dry weight in F1+F2 and F+B treatment as
compared to all other tested treatments. Physicochemical parameters also
showed a substantial decrease except TDS that showed an increasing trend.
Minimum values of all were observed in combined microbial treatment as
compared to control and other treatments.
The chlorophyll content of leaves in all selected plants decreased with
increasing the concentration of industrial sludge. Plants growing in different
concentration of sludge, supplemented with combined fungal treatments in pot
experiments and F+B treatments in field experiments, showed higher chlorophyll
contents than the plants growing in other treatments. Results revealed that all the
tested plants species showed a higher accumulation of essential (Ca, K, Na and
iii
Mg) and heavy (Cd Cr, Cd, Zn, Cu and Pb) metals at 60% concentration of
sludge as compared 0 and 30% after 90 days of plant growth. The metal uptake
was higher in their shoots as compared to roots in case of all the plant species, in
both paper and tannery sludge. Further, the uptake of metals was significantly
higher in F1+F2, B1+B2 and F+B treatment as compared to rest of the
treatments i.e. F1, F2, B1, B2, F, B alone and control treatment. The metal
extraction efficiency of the experimental plants was observed to be in the order of
T. angustifolia > H. compressa > L. minor. The translocation factor and
enrichment coefficient indicated that a higher amount of heavy metals was
absorbed by the plants than was present in the sludge. The least
bioaccumulation was observed for Na in all the cases. Typha angustifolia proved
to be a better metal accumulator than all other hydrophytes. Biochemical analysis
of T. angustifolia and H. compressa showed that in 60% TS with combine fungal
and bacterial inoculum, superoxide dismutase (SOD) and catalase (CAT) activity
was high i.e. in the order of 60% TS> 30% TS> 0% TS.
The results from this work in the light of contemporary literature indicates
that a probable genetic modification at cellular level resulted in an acquisition of
metal tolerance that was also evident in enhanced biochemical activity of
antioxidant enzymes, uptake of high metal contents and ultimately better plant
growth in all the treatments as compared to control. The results of these
experiments emphasize that efficient pollution hyperaccumulators can be used
for commercial and large-scale cleaning and bioremediation of tannery sludge.
The plants can then be harvested easily and incinerated. Constructed wetlands
offer the treatment benefits of natural wetlands in a more controlled environment,
if developed along the industrial units. The treatment processes within such a
system will be self- sustainable, requiring little input of energy, chemicals and
operator maintenance