• Impact of Load Modeling on DG Integrated Distribution Systems 

  Khan, Muhammad Faisal Nadeem (DEPARTMENT OF ELECTRICAL ENGINEERING, FACULTY OF ELECTRONICS & ELECTRICAL ENGINEERING, UNIVERSITY OF ENGINEERING AND TECHNOLOGY TAXILA, 2019-01-01)

  Renewable energy based Distributed Generation (DG) resources are crucial for sustainable energy supply infrastructure as they are non-polluting and inexhaustible. The uncertainties associated with DG resources may cause ...
• Design and Analysis of Metasurfaces for Polarization Conversion of Electromagnetic Waves 

  Khan, Muhammad Ismail (Department of Electrical Engineering, College of Electrical and Mechanical Engineering National University of Sciences and Technology, Pakistan., 2018-05-01)

  Control and manipulation of polarization state of electromagnetic waves has always been of interest in the scientific community due to its fundamental role in wide range of applications including contrast imaging microscopy, ...
• Multi-resolution Transform based Feature Extraction Techniques for Differentiating Glioma Grades using MRI Images 

  Zia, Razia (Department of Electrical Engineering, Pakistan Navy Engineering College, Karachi, National University of Sciences and Technology, Pakistan., 2018-01-01)

  Medical image processing is one of the most attention gaining research areas that utilizes the technology for improving the quality of human life through a more precise and rapid diagnosis systems. This thesis focuses on ...
• Soft Computing Methodologies for Hybrid Renewable Energy Sources in Smart Grid Adaptive Control 

  Mumtaz, Sidra (Department of Electrical Engineering, COMSATS University Islamabad, Abbottabad Campus, Pakistan., 2018-10-01)

  Owing to the evolution of the smart grid, the emergence of hybrid renewable energy system (HRES) and the proliferation of plug-in-hybrid electric vehicles (PHEVs), the development of efficient and robust maximum power ...
• Adaptive Optical Beam Control for Rangefinders and Delay Lines 

  Khwaja, Tariq Shamim (Department of Electrical Engineering, Syed Babar Ali School of Science and Engineering, Lahore University of Management Sciences (LUMS) Lahore, Pakistan., 2018-01-01)

  In this thesis, the use of adaptive optics to exercise control over the fundamental TEM00 Gaussian laser beam is employed for applications in optical metrology and photonic signal processing. Split into two parts, this ...
• Scalable DC Microgrids for Rural Electrification 

  Nasir, Mshood (Syed Babar Ali School of Sciences and Engineering Lahore University of Management Sciences (LUMS) Lahore, Pakistan., 2018-01-01)

  Access to electricity is one of the key factors indicating the socio-economic status of any community. Reliable and adequate provision of electricity is mandatory for improved standards of living including better health, ...
• OPTIMAL FLEXIBLE ANTENNA DESIGNS FOR FUTURE WBAN 

  Dar, Saadat Hanif (DEPARTMENT OF ELECTRICAL ENGINEERING, RIPHAH INTERNATIONAL UNIVERSITY, ISLAMABAD, PAKISTAN, 2018-03-01)

  Health and long term care is growing exponentially in wearable biomedical systems. Wearable and flexible diagnostic systems can contribute towards the timely care of patients suffering with chronic health conditions, ...
• Advanced Image Reconstruction Algorithms in MRI 

  Irfan Ullah (Department of Electrical Engineering, COMSATS Institute of Information Technology Islamabad-Pakistan., 2018-10-01)

  Magnetic Resonance Imaging (MRI) is a non-invasive and non-ionizing medical imaging technique that provides essential clinical information about both the anatomy and physiology of the human body. One of the major limitations ...
• Link to System (L2S) Interfacing for Advanced Receiver Strategies 

  Khan, Asif (Department of Electrical Engineering, COMSATS University Islamabad Abbottabad Campus – Pakistan, 2017-10-01)

  The size and complexity of wireless communication networks have grown tremendously over the last few decades. Analysis of a wireless communication system requires computer simulations of the entire communication network, ...
• On the Capacity of an Average and Peak Power Constrained Optical Wireless Relay Channel 

  Raza, Allah Ditta (Department of Electrical Engineering, National University of Computer and Emerging Sciences, Lahore Campus, Punjab, Pakistan., 2015-11-01)

  Ever evolving bandwidth hungry applications present a gigantic challenge and an unprecedented opportunity for wireless communication. Radio spectrum is already congested. The researchers are vigorously pursuing efficient ...
• Adaptive High Throughput CDMA-based Wideband Waveform with Robust Timing and Frequency Synchronization for SDR-based Tactical Networks 

  Zeeshan, Muhammad (Department of Electrical Engineering College of Electrical and Mechanical Engineering National University of Sciences and Technology Pakistan., 2015-01-01)
• Propofol Anesthesia; Regulation of Hypnosis using Nonlinear Control Techniques 

  Khaqan, Ali (Department of Electrical Engineering, COMSATS Institute of Information Technology Islamabad-Pakistan., 2016-10-01)

  Advance technologies and engineering applications have played a significant role in the design and improvement of clinical procedures during the last few decades. Control of drug infusion for patients health and safety ...
• Optimal Design of a Coreless Axial Flux Permanent Magnet Synchronous Generator for the Wind Power Generation 

  Ikram, Junaid (Department of Electrical Engineering, COMSATS Institute of Information Technology Islamabad-Pakistan., 2017-03-01)

  Renewable power generation from wind and solar are gaining popularity to overcome energy crisis nowadays. A lot of advancement has been focused on wind power generation instead of fossil fuels that are degrading to the ...
• OUTPUT FEEDBACK STABILIZATION AND REGULATION FOR A CLASS OF UNDERACTUATED NON-MINIMUM PHASE BENCHMARK NONLINEAR SYSTEMS 

  Khalid, Nasir (Department of Electrical Engineering, National University of Sciences and Technology, Islamabad, Pakistan, 2017-09-01)

  In this thesis, the problem of output feedback stabilization and regulation for a class of underactuated benchmark nonlinear systems is considered. The proposed method utilizes an extended high gain observer (EHGO)-based ...
• Modeling and Simulations of Metamaterial based Microwave Devices 

  Asim, Muhammad Tauseef (Department of Electrical Engineering Pakistan Institute of Engineering and Applied Sciences Nilore, Islamabad, Pakistan., 2017-01-01)

  Dual layer periodically patterned metamaterial inspired antennas on a low cost FR4 substrate are designed and simulated. Some of the designed antennas are also fabricated and tested. Eigen mode dispersion simulations are ...
• 3D FACE RECOGNITION BASED ON POSE AND EXPRESSION INVARIANT ALIGNMENT 

  Ratyal, Naeem Iqbal (Department of Electrical Engineering, Faculty of Engineering, Capital University of Science & Technology, Islamabad, Pakistan, 2016-11-01)

  3D face recognition has made considerable progress during the last decade as an emerging biometric modality. In order to ensure reliable 3D face recognition, novel 3D alignment and recognition algorithms are proposed in ...
• Geometric Modeling and Characterization of 3-D Land Mobile Radio Cellular Propagation Channels 

  Ahmed, Abrar (Department of Electrical Engineering, COMSATS Institute of Information Technology Islamabad-Pakistan, 2016-10-01)

  Accurate knowledge of radio channel characteristics is of immense importance to meet the dynamic requirements of the emerging fifth generation (5G) communication networks. The existing widely used radio channel models are ...
• Segmentation and Classification of Brain Tumor MR Images through Advance Machine Learning Methods 

  Farhi, Lubna (Department of Electrical Engineering, National University of Sciences and Technology, Islamabad, Pakistan, 2018-03-01)

  The main objective of this research work is to develop, test and evaluate an identification support system that is able to provide accurate, fast and reliable diagnosis of brain tumor in MR images. Keeping in consideration ...

View more