Abstract:
Precise milling of thin-walled components is a difficult task process owing to the geometric complexity and low
stiffness connected with them. This paper is concerned with a systematic comparative study between predicted and
measured surface roughness. RSM and ANN applied in prediction and optimization of milling thin-walled steel
components. Cutting speed, feed rate, radial and axial depth of cut are the main affecting process parameters on surface
roughness. In order to protect our precious environment, this work utilized vegetable oil as biodegradable cutting fluids
that resolve the lowest amount of ecological contamination provide well economic conditions. The milling have done
under flood cooling and using uncoated carbide as cutting tool. The results indicate that the RSM and ANN models are
very close to the experimental results, ANN predictions show better convergence than the RSM model. The best of surface
roughness value (0.314 µm) can be achieved with a desirability of 98.6%, cutting speed, feed rate, radial and axial depth of
cut were 125 m/min, 0.04 mm/tooth, 0.25 mm and 10 mm, respectively. The best configuration of the ANN structure was
4-16-1. The feed rate cause most significant effect on surface roughness, followed by axial and radial depth of cut.